Displaying The Status Of Surrogate Features - IBM Nways 8260 Manual

Figure 133. Displaying the Status of Surrogate Features
10.7.1.2 Enabling Individual Options within the Surrogate Groups
Once the surrogate features are enabled, you may enable the individual
surrogate options within the surrogate groups, using the following commands:
SET TR_SURROGATE {slot.subslot} REM_STATUS {options}
SET TR_SURROGATE {slot.subslot} CRS_STATUS {options}
SET TR_SURROGATE {slot.subslot} CRS_STATIONS {options}
For details of the permitted options, please refer to the DMM Command Guide ,
SA33-0275.
You can display the status of individual options within each surrogate group
using the following commands:
234
8260 Multiprotocol Intelligent Switching Hub
8260A> show tr_surrogate 8.2 surr_status
Surrogate Status Data for Network TOKEN_RING_7
------------------------------------------------------------------------
Surrogate Admin Status:
Port Mac Address:
Ring Segment:
Ring Utilization:
REM Admin Status:
REM Oper Status:
CRS Admin Status:
CRS Oper Status:
8260A>
Status of REM options
SHOW TR_SURROGATE {slot.subslot} REM_STATUS
An example of the output from this command is shown in Figure 134 on
page 235.
ENABLED
10-00-f1-0b-58-00
0000
0.0%
ENABLED
Active
ENABLED
Active