Configuring Port Parameters; Lms Download Parameters Panel - IBM Nways 8260 Manual

Figure 144. LMS Download Parameters Panel

11.8.2 Configuring Port Parameters

To configure the ports on the Multiprotocol Interconnect module, you must select
Port Menu from the Configuration Menu . The panel shown in Figure 145 on
page 256 will be displayed.
Note
If you select Start BOOTP Download and do not specify the TFTP server
IP address and TFTP filename in the above panel, the Multiprotocol
Interconnect module will use BOOTP to locate a BOOTP server in the
network in order to get this information to perform the download
operation.
To perform download from a PC attached to the Multiprotocol Interconnect
module s serial port, select Start Serial Download .
Config * Download Parameters
System
TFTP Server: 9.67.46.45
TFTP Filename: bld.op
Start Serial Download
Module: BladeRunner
Time:
TFTP Status: idle
Start BootP Download
Chapter 11. 8260 Multiprotocol Interconnect Module
15:26 5 Jan 95
Exit
255