Lms Trap Destination Panel - IBM Nways 8260 Manual

Figure 143. LMS Trap Destination Panel
3. Download Parameters
254
8260 Multiprotocol Intelligent Switching Hub
To add an entry to this table, you must select Add Entry from the Menu Bar
options of the panel shown in Figure 143 on page 254. You will then be
prompted (via a pop-up menu) to enter the IP address and the community
name of the SNMP manager. After entering this information you must select
(on the pop-up menu) Set Entry to add this entry to the table or Cancel to
abandon the operation.
Config * Trap Destination Table
System
IP Address Community Name
9.67.46.45 public
Add Entry
You can download new software into the Multiprotocol Interconnect module
using one of the following two ways:
Using BOOTP/TFTP over the network
Using a PC attached to the Multiprotocol Interconnect module s RS-232
port
Download Parameters panel shown in Figure 144 on page 255 allows you to
specify the download method to be used and also allows you to start the
operation.
Using this panel, you must enter the following parameters for the
BOOTP/TFTP method:
TFTP Server IP Address
TFTP Filename
Once the above parameters are entered, you can select Start BOOTP
Download to start the download. The TFTP Status field on the screen will
display the current status of the TFTP operation.
Module: BladeRunner
Time: 15:21 5 Jan 95
Exit