Port 10Base-Fb Dip Switches; Port 10Base-Fb Module Dip Switch Settings - IBM Nways 8260 Manual

Figure 74. 10-Port 10Base-FB DIP Switches
The DIP switches let you perform the following:
Use DIP switch positions 1 through 4 to assign all the ports on the module to
one of the backplane segments or isolated-1 segment. Note that when using
DIP switches, all the ports will be assigned to the same segment, so in
effect, you cannot do per-port switching.
Table 17 on page 103 shows the meaning of settings for DIP switches 1 thru
4:
Table 24. 10-Port 10Base-FB Module DIP Switch Settings
Network Selection
Ethernet_1
Ethernet_2
Ethernet_3
Ethernet_4
Ethernet_5
Ethernet_6
Ethernet_7
Ethernet_8
Isolated_1
Switch 1 Switch 2
ON ON
OFF ON
ON OFF
OFF OFF
ON ON
OFF ON
ON OFF
OFF OFF
ON ON
Chapter 7. 8260 Ethernet Modules
Switch 3 Switch 4
ON ON
ON ON
ON ON
ON ON
OFF ON
OFF ON
OFF ON
OFF ON
ON OFF
117