Lms Configuration Panel - IBM Nways 8260 Manual

Figure 178. LMS Configuration Panel
11. If you have not defined the conversion information for an imported RIP entry,
300
8260 Multiprotocol Intelligent Switching Hub
Config * OSPF Rip Convert Table
System
IP Address IP Mask
9.67.46.0 255.255.255.240
9.67.46.0 255.255.255.240
9.67.46.0 255.255.255.240
9.67.46.0 255.255.255.240
9.67.46.0 255.255.255.240
9.67.46.0 255.255.255.240
9.67.46.0 255.255.255.240
9.67.46.0 255.255.255.240
9.67.46.0 255.255.255.240
9.67.46.0 255.255.255.240
Modify Entry
Return to the previous screen
This panel allows you to enter the following parameters for each entry:
IP Address
This parameter specifies the destination IP address found by RIP.
IP Mask
This parameter specifies the destination IP address mask.
Hop Count
This parameter specifies hop count measured in RIP.
Metric
This parameter specifies the metric in OSPF converted from RIP.
the RIP Default Conversion Table will be used. This table is set with a
number of default entries when the Multiprotocol Interconnect module is
shipped. You can view and/or modify the contents of this table by selecting
OSPF RIP Default Convert Table from the OSPF Menu panel. The resulting
display is shown in Figure 179 on page 301.
Module: BladeRunner
Page 1 Time:
Hop Count
1
2
3
4
5
6
7
8
9
10
Prev Page Next Page
17:46 11 Jan 95
Metric
10
20
30
40
50
60
70
80
90
100
Exit