Lms System Parameters Panel - IBM Nways 8260 Manual

Warmstart : All the configuration settings are read from the FLASH
memory, resulting in the restoration of the last saved configuration
information. Note that all the statistics tables will be cleared during
to a Warmstart .
The Menu Bar options of the Systems Parameters screen allow you to
perform the following:
Reset Unit
This enables you to initiate an immediate reset of the Interconnect
module. When you choose this option, you will be prompted to enter
Reset or Cancel to proceed.
Change Password
This allows you to change the module s password for write access . The
length of the password can be up to 64 characters and you will be
prompted to enter the password twice.
Exit
Allows you to return to the previous (Configuration Menu) screen.
An example of the System Parameters panel is shown in Figure 142.
Config *
System
Name: BladeRunner
Location: ITSO Lab, Raleigh
Contact: Mohammad Shabani X2339
Station Time: 14:29 5 Jan 95
Next Reset: warmStart
Reset Module
Figure 142. LMS System Parameters Panel
2. Trap Destination Table
As shown in Figure 143 on page 254, this panel allows you to specify the
SNMP managers to which the Traps are sent.
There can be up to a maximum of eight entries specified in this table and
each entry contains the following parameters identifying an SNMP manager
and its authority:
IP Address
Community Name
System Parameters
Change Password
Return to the previous screen
Chapter 11. 8260 Multiprotocol Interconnect Module
Module: BladeRunner
Time: 14:29 5 Jan 95
Exit
253