Lms Custom Filter Statement Table - IBM Nways 8260 Manual

Config * Custom Filter Statement Table
Log. Port: 1 LOGICAL PORT
Statement ID Test Name
1 Frame Type Test
2
3
4
5
6
7
8
9
10
Modify Entry Prev Page
Figure 159. LMS Custom Filter Statement Table
The port to which the table applies is displayed on the top left hand corner of
the screen. You can use the Prev Port and Next Port options on the Menu
Bar to select the required port.
This table allows you to apply up to 16 tests on the frames received on each
port.
To configure a new entry in the table, you must select Modify Entry and type
the entry s Statement ID . Once you have entered the information for the
entry, you must select Set Entry and press Enter to confirm or select Cancel
to abandon the operation. The following parameters can be specified for
each entry in the Custom Filter Statement Table:
ID Number
This is the number assigned to the selected test in the Custom Filter Test
Table .
Test Name :
This is the name assigned to the selected test in the Custom Filter Test
Table .
Action on Success
This parameter specifies the action to be taken by the Multiprotocol
Interconnect module when the test is successful.
Action on Failure
This parameter specifies the action to be taken by the Multiprotocol
Interconnect module when the test is unsuccessful.
For both the Action on Success and Action on Failure , the following
values can be specified:
Discard: Discard the frame
Page 1
Action on Success
Stmt 2
Discard
Discard
Discard
Discard
Discard
Discard
Discard
Discard
Discard
Next Page Prev Port
Return to the previous screen
Chapter 11. 8260 Multiprotocol Interconnect Module
Module: BladeRunner
Time: 14:10 9 Jan 95
Action on Failure
Discard
Discard
Discard
Discard
Discard
Discard
Discard
Discard
Discard
Discard
Next Port Exit
277