Lms Boothelper Parameters Panel - IBM Nways 8260 Manual

Also a BOOTP client can request the code image file to be downloaded from
the TFTP server.
To configure the Multiprotocol Interconnect module as a Boothelper you
must select Boothelper Parameter from the Protocols Menu . An example of
the Boothelper Parameters panel is shown in Figure 167.
Config * Boothelper Parameters
System
Boothelper: Enabled
Forward Address: 9.67.46.45
Figure 167. LMS Boothelper Parameters Panel
This screen allows you to display and configure module-wide Boothelper
parameters for the Multiprotocol Interconnect module. The following
parameters can be specified using this panel:
Boothelper
If this parameter is disabled, all the BOOTP datagrams are discarded by
the Multiprotocol Interconnect module. If enabled, they will be forwarded
to the address specified by Forward Address parameter.
Forward Address
This is either the IP address of the BOOTP server (if the BOOTP server is
directly connected to the module) or the IP address of the next
Boothelper router in the path to the BOOTP server.
Hop Count
This parameter restricts the number of Boothelpers that BOOTP
messages may traverse before reaching the BOOTP server. The
message will be discarded if the number of hops is equal to or exceeds
the value configured for this parameter.
In this example, the station with IP address 9.67.46.45 is an RS/6000
workstation configured as a BOOTP server.
10. If you are planning to use OSPF, you must configure the Multiprotocol
Interconnect module for OSPF as described in the following section.
Hop Count: 3
Exit
Return to the previous screen
Chapter 11. 8260 Multiprotocol Interconnect Module
Module: BladeRunner
Time: 10:51 11 Jan 95
287