Lms Physical Port Protocol Configuration Panel - IBM Nways 8260 Manual

Config * Physical Port Protocol Parameters
Phy. Port: 7 PHYSICAL PORT
Link Protocol: tokenRing
Commands: noOp
Act Mon Part: false
Search Port
Figure 148. LMS Physical Port Protocol Configuration Panel
This panel allows you to specify the following options:
Commands
This entry allows you to configure the operational status of the token-ring
port. The following options are available:
Open: tells the adapter to enter the ring.
Close: tells the adapter to remove itself from the ring.
Reset: causes an immediate reset of the token-ring port.
Noop: has no effect; it simply indicates that an open operation has not
been requested.
Ring Speed
This parameter allows you the set the speed at which the token-ring port will
operate.
Act Mon Par
This parameter allows you to specify if the station is to participate in the
active monitor selection process. The choices for this parameter are:
True
False
Funct MAC Addr Mask
This parameter allows you to specify the bit mask that is applied to all
functional addresses for which this port accepts frames.
Ring Speed:
Funct MAC Addr Mask:
Prev Port Next Port
Return to the previous screen
Chapter 11. 8260 Multiprotocol Interconnect Module
Module: BladeRunner
Time: 15:56 5 Jan 95
fourMegabits
C00000000000
Exit
259