Snmp Support; Lms Jump Table - IBM Nways 8260 Manual

Figure 140. LMS Jump Table

11.7 SNMP Support

The Multiprotocol Interconnect module provides an SNMP agent which can be
used to manage the Multiprotocol Interconnect module via an SNMP manager.
To access the SNMP agent, the SNMP manager is required to provide the
correct community name as defined in the Multiprotocol Interconnect module.
The process of defining community names for the Multiprotocol Interconnect
module is described in 11.8.1, "Configuring System Wide Parameters" on
page 252.
Depending on the community name settings, the SNMP agent may support any
of the following options for an SNMP manager:
The following MIBs are supported by the SNMP agent:
250
8260 Multiprotocol Intelligent Switching Hub
Config * Jump Table - Config screens
System Download
Phy. Port Protocol Phy. Port Interface Logical Port
Bridging System Bridging Port
Filtering Database Custom Filter Test Custom Filter Stmt. Src. Routing System
Conversion System IP System
IP NetToMedia Table IP Forwarding
IP BootHelper IP Ping
DECnet Area Routing DECnet Routing
IPX System IPX Port
IPX Security List IPX Security Table OSPF System
OSPF Area Def. Met. OSPF Address Range OSPF Host
OSPF IF Metric OSPF Virtual IF
OSPF RIP Convert OSPF RIP Def. Conv. OSPF Static Filter OSPF Static Convert
OSPF St. Def. Conv.
Status Screens
Return to the previous screen
Close Connection :
This option will only be displayed if you have accessed the Multiprotocol
Interconnect module using Telnet. In that case, this option allows you to
close the connection when required.
Get-request
Get-next-request
Set-request
Get-response
Trap
MIB-II
Dot1dBridge Group
Module: BladeRunner
Time: 14:25 5 Jan 95
Trap Dest. Table Physical Port List
Logical Port MLink
STP System STP Port
IP Port IP Port Address
IP Security List IP Security Table
DECnet System DECnet Port
DECnet Sec. List DECnet Sec. Table
IPX Routing IPX SAP Bindery
OSPF Area Table
OSPF Interface
OSPF Neighbor OSPF RIP Filter
Exit