Configuring The Interconnect Module Using Lms - IBM Nways 8260 Manual

The following SNMP traps will be sent by the SNMP agent to the SNMP
managers which have been defined as a trap receiver .

11.8 Configuring the Interconnect Module Using LMS

To configure the Multiprotocol Interconnect module, you must have a write
session and must select configuration from the initial LMS menu. The panel
shown in Figure 141 on page 252 will be displayed.
Using this panel you can configure the following features:
Dot5 Group
Frame Relay Group
IP Forward Group
OSPF Group
PPPF Group
Retix Private MIB extensions
coldStart
linkUp
Enterprise specific traps:
frDCLiStatusChange
newRoot
Retix Enterprise specific traps:
logicalPortUp
logicalPortDown
fpUp
fpDown
hardwareFail
temperatureOverheat
powerSupplyFail
System wide parameters
Port parameters
Bridging parameters
Routing parameters
Chapter 11. 8260 Multiprotocol Interconnect Module
251