Lms Physical Port List For Ethernet Connections - IBM Nways 8260 Manual

applicable to the LAN ports and will not be discussed any further in this
book.
11.8.2.1 Configuring Physical Port Parameters
The Physical Port List panel displays information about the physical ports
currently installed on your module. An example of this panel is shown in
Figure 146.
Config * Physical Port List
System
Port ID Name
1 PHYSICAL PORT
2 PHYSICAL PORT
3 PHYSICAL PORT
4 PHYSICAL PORT
5 PHYSICAL PORT
6 PHYSICAL PORT
Prev Page
Figure 146. LMS Physical Port List for Ethernet Connections
Note that the above panel also shows the list of backplane Ethernet connections
for ports 1 thru 6. As can be seen from this panel, port 1 was assigned to
Ethernet_1 segment on the backplane using DMM commands.
Selecting the Next Page option on this panel allows you to display the port list
for any I/O cards that may be installed on your Multiprotocol Interconnect
module. In our example, we had two token-ring I/O cards, so the resulting
display is shown in Figure 147 on page 258.
Page 1
Connection Card
Ethernet-1 0
Isolated 0
Isolated 0
Isolated 3
Isolated 3
Isolated 3
Next Page
Return to the previous screen
Chapter 11. 8260 Multiprotocol Interconnect Module
Module: BladeRunner
Time: 15:39 5 Jan 95
Type Protocol
Backplane csmaLan
Backplane csmaLan
Backplane csmaLan
Backplane csmaLan
Backplane csmaLan
Backplane csmaLan
Exit
257