Lms Physical Ports List For Token-Ring I/O Cards - IBM Nways 8260 Manual

Figure 147. LMS Physical Ports List for Token-Ring I/O Cards
Using the Physical Port List panel, you may configure a name for each LAN port.
To configure a particular entry, select the entry and press the Enter key. A
pop-up menu as shown in Figure 148 on page 259 will be displayed which
allows you:
11.8.2.2 Configuring Physical Port Protocol Parameters
An example of the Physical Port Protocol Parameters panel for a token-ring I/O
card is shown in Figure 148 on page 259.
258
8260 Multiprotocol Intelligent Switching Hub
Config * Physical Port List
System
Port ID Name
7 PHYSICAL PORT
8 PHYSICAL PORT
Prev Page
To configure a name for the physical port.
To configure a new protocol for the port. This option is only available for the
WAN ports.
To change the configuration of the protocol on the port. This option is only
available for the token-ring and WAN ports. It is not applicable to Ethernet
ports.
Note: This pop-up menu is the same as that displayed when selecting
Physical Port Protocol Parameters from the Port Menu .
Module: BladeRunner
Page 2 Time:
Connection Card Type
FRONT PANEL 1 tokenRing
FRONT PANEL 2 tokenRing
Next Page
15:49 5 Jan 95
Protocol
tokenRing
tokenRing
Exit