Set Device Name Command For Dmm; Set Device Location Command For Dmm; Set Device Contact Command For Dmm - IBM Nways 8260 Manual

This command sets the clock to 3:45 p.m., Thursday, Jan 19th, 1995. The
clock is driven by an internal battery which is designed to last for 10 years.
Set Device
This command allows you to configure the following for DMM:
Device name
This command allows you to configure a name for DMM. It is
recommended that each DMM in the network be assigned a unique
name. The name can be a maximum of 31 characters long. It is a good
idea to make sure that the name of the DMM and the prompt of the
terminal which is directly attached to it match each other.
The following command assigns the device name of 8260A to this DMM:
8260> set device name
> Enter device name:
> 8260A
Device name changed.
8260A>
Figure 23. Set Device Name Command for D M M
Device location
This command allows you to describe the location of the 8260 in which
this DMM is installed. An example of this command is as follows:
8260A> set device location
Enter one line of text:
> ITSO LAB, Building 657, Raleigh
Location changed.
8260A>
Figure 24. Set Device Location Command for D M M
Note that you can enter up to 78 alphanumeric characters to specify the
location of the DMM.
Device contact
This command allows you to specify the name of the person responsible
for maintaining the 8260 in which this DMM is installed. An example of
this command is as follows:
8260A> set device contact
Enter one line of text:
> Mohammad Shabani, 301-2339
Contact changed.
8260A>
Figure 25. Set Device Contact Command for D M M
Note that you can enter up to 78 alphanumeric characters to specify the
contact name for the DMM.
Device diagnostics
Chapter 4. 8260 Distributed Management Architecture
51