Configuring For Ipx Routing; Lms Ipx Menu Panel - IBM Nways 8260 Manual

3. Enable IP security on the module, using the IP System Parameters panel.
4. Specify up to two IP security lists for each IP port using the IP Port

11.8.10 Configuring for IPX Routing

The Multiprotocol Interconnect module allows you to configure it as an IPX
router. To do so, you must perform the following steps:
1. Configure the system-wide parameters for the Multiprotocol Interconnect
2. Configure the port parameters for the Multiprotocol Interconnect module s
3. Select IPX from the Protocols Menu . A panel as shown in Figure 185 will be
Figure 185. LMS IPX M e n u Panel
308
8260 Multiprotocol Intelligent Switching Hub
ICMP Generation
This field specifies whether an ICMP Destination Unreachable message
is forwarded to the source address on any IP datagram that is discarded
because of security checks.
Note: There is only one IP security access list per Multiprotocol Interconnect
module.
IP security access list may contain up to 32 entries.
Parameters panel.
Note: A single IP security table may be active on any number of ports at the
same time.
module as described in 11.8.1, "Configuring System Wide Parameters" on
page 252.
ports as described in 11.8.2, "Configuring Port Parameters" on page 255.
displayed.
Config *
Enter the IPX system parameters screen
This panel allows you to access all the panels for viewing and configuring
the IPX parameters supported by the Multiprotocol Interconnect module.
IPX Menu Module: BladeRunner
Time:
IPX System Parameters
IPX Port Parameters
IPX Routing Table
IPX SAP Bindery Table
IPX Security Access List
IPX Security Table
Exit
10:49 13 Jan 95