Lms Ip Forwarding Table Panel - IBM Nways 8260 Manual

7. Optionally, you may specify one or more static routes to be used by the
Figure 165. LMS IP Forwarding Table Panel
284
8260 Multiprotocol Intelligent Switching Hub
that the Multiprotocol Interconnect module recognizes both types of
broadcasts on the received frames regardless of the setting of this
parameter.
Forward Broadcast
This parameter specifies if this port will forward directed broadcast
messages. Directed broadcasts have all 1 s in the hostid portion of their
address.
Security Access List n
This parameter specifies the security access list associated with this
port. You may assign two security access lists with a single logical port.
IP security must be enabled at the module level for the security feature
to be active. Note that a value of 0 indicates that this list is inactive.
For more information about IP security, refer to 11.8.9, "IP Security" on
page 304.
Multiprotocol Interconnect module. To do so you must select IP Forwarding
Table from the IP menu . An example of the IP forwarding table is shown in
Figure 165.
Config * IP Forwarding Table
System
Destination Next Hop
9.67.46.0 0.0.0.0
9.67.46.16 0.0.0.0
9.67.46.32 0.0.0.0
9.67.46.224 9.67.46.46
Add Entry Search Addr
Return to the previous screen
This table allows you to create static routes which can be used by the
Multiprotocol Interconnect module to determine on which port each
datagram should be transmitted. It also allows you to display the current
routing tables used by the Multiprotocol Interconnect module. The following
entries can be viewed/modified using this table:
Destination
This field can be either a host address, a subnet address, or a network
address.
Module: BladeRunner
Page 1 Time:
Mask Type
255.255.255.240 local
255.255.255.240 local
255.255.255.240 local
255.255.255.240 remote
Prev Page Next Page
16:08 9 Jan 95
Port Protocol Metric1
1 local 1
2 local 1
1 local 1
1 netmgmt 1
Exit