Recovery Asic In Per-Port Switching Module; Display Output For 20-Port Passive Module - IBM Nways 8260 Manual

Figure 94. Recovery ASIC in Per-Port Switching Module
You can find out the MAC address of the Recovery ASIC on each module by
using the following DMM command:
SH MODULE {slot.subslot} VERBOSE
Figure 95 showsDisplay the output from this command for a 20-port passive
token-ring module.
Figure 95. Display Output for 20-Port Passive Module
Figure 96 on page 157 shows the output from this command for an active 18-port
per-port switching token-ring module.
156
8260 Multiprotocol Intelligent Switching Hub
8260> show module 5.1 verbose
Slot Module Version Network
----- --------------- ------- ------------- -------------------
05.01 T20MS v1.00
T20MS: Token Ring Passive Module Switching Twisted Pair
Boot Version:
Ring Speed Dip Setting:
Dip Network Setting:
Non-Volatile DIP Setting:
Recovery Asic Primary Address:
Recovery Asic Secondary Address:
Beacon Threshold:
Speed Detect Threshold:
8260>
General Information
TOKEN_RING_10 Port(s) are down
v1.00
16 MBPS
TOKEN_RING_1
ENABLED
08-00-8f-d0-38-43
08-00-8f-d0-38-83
255
15