Show Counter Command For Token-Ring Networks; Rmon Host Statistics Display - IBM Nways 8260 Manual

Figure 123. RMON Host Statistics Display

10.6.5 SHOW COUNTER Command for Token-Ring Networks

This command allows you to display the following information about the
segments to which the DMM has an interface via a T-MAC:
1. Display error statistics for a token-ring segment
222
8260 Multiprotocol Intelligent Switching Hub
8260A> show rmon host data 1 all by_creation_order
RMON Host display for Interface 3 :
Creation Order
Host Address
Input Packets
Output Packets
Input Octets
Output Octets
Output Errors
Output Packets (Broadcast)
Output Packets (Multicast)
Creation Order
Host Address
Input Packets
Output Packets
Input Octets
Output Octets
Output Errors
Output Packets (Broadcast)
Output Packets (Multicast)
-- More --
................
End of Host Table
You can display the error statistics (DOT5) for token-ring segments using the
following command:
SHOW COUNTER TOKEN_RING {token_ring_n}
Note: These counters are not related to RMON.
An example of the output displayed for this command is shown in Figure 124
on page 223.
: 1
: 10-00-5A-D4-B0-8C
: 2954
: 2954
: 301308
: 301308
: 0
: 0
: 0
: 2
: 10-00-5A-82-5A-6A
: 2963
: 2963
: 301960
: 301960
: 0
: 0
: 0