Configuring An Ip Address On The Switch Using The Cmm Gui; System Status Led: Power - IBM Flex System EN4023 User Manual

2
Configuring the switch
7.
FIGURE 15
8. Use SSH to open a session to the switch using the newly configured IP address. Log in to the
NOTE
The passwords that are used to access the switch are case-sensitive. To increase system security,
change the password after you log in for the first time. For more information, see the Network OS
Administrator's Guide.

Configuring an IP address on the switch using the CMM GUI

For IPv4
1. Install the IBM Flex System EN4023 10Gb Scalable Switch in the appropriate bay of the IBM
2. Log in to the CMM using the following default user name and password settings:
3. From the CMM GUI, navigate to Chassis Management > Component IP Configuration.
4. Select the I/O Module bay in which the switch is installed. The example in
26
From the CMM, enter ifconfig to confirm that the new IP address has been applied. See
Figure 15.
Verifying the IP address using the CMM CLI
switch using the following default user name and password settings:
User ID: admin
Password: password
Flex System chassis. For more information, see
User ID: USERID
Password: PASSW0RD (wherein the sixth character is a zero)
"IO Module 3."
The IP Address Configuration IO Module (for the selected bay) dialog box displays.
"Installing the switch" on page 11.
IBM Flex System EN4023 10Gb Scalable Switch User's Guide
Figure 16 is using