Cli Command Format - IBM Flex System FC3171 Installation And User Manual

5. Normally, the date and time are set by the CMM through NTP. However, as an
6. Type admin end and press Enter to exit from the administrator operating mode
Note:
the applicable documentation that is listed in "CLI command format" on page 30.

CLI command format

The information in this section is an overview of the CLI command format. For
detailed information about using CLI commands, see the applicable documentation
at http://publib.boulder.ibm.com/infocenter/flexsys/information/index.jsp.
• IBM Flex System Chassis Management Module Command-Line Interface Reference
• IBM Flex System FC3171 8 Gb SAN Switch Command Line Interface User's Guide
• IBM Flex System FC3171 8 Gb Pass-thru Command Line Interface User's Guide
A command is followed by one or more keywords. The following rules apply when
you type keywords:
• Commands and keywords are lowercase and case sensitive.
• Required keyword values are shown in standard font: [value]. Optional values
• The underlined portion of each keyword indicates the abbreviated form that can
The CLI command syntax is as follows:
• keyword
• keyword [value]
• keyword [value 1][value 2]
You can change items in brackets ([ ]) by typing a new value. You can use the
Backspace and Delete keys to erase characters behind and in front of the cursor.
30
IBM Flex System FC3171 8 Gb SAN Switch and Pass-thru Installation and User's Guide
option, you can set the date and time of the switch by typing date
[MMDDhhmmCCYY] where:
[MM] is the month
[DD] is the day
[hh] is the hour in 24-hour format
[mm] is the minute
[CC] represents the century identifier
[YY] represents the last two numbers of the year
For example, the format for November 28 2011 8:46 p.m. is date 112820462011.
Press Enter.
and return to the standard operating mode.
For more information about password requirements and using the CLI, see
Guide
are shown in italics [value].
be used. For example, the Delete keyword can be abbreviated as Del.