Displaying And Debugging Snmp; Snmp Configuration Example - 3Com 5500-SI Configuration Manual

570 C 28: SNMP C
HAPTER
Displaying and
Debugging SNMP
SNMP Configuration
Example
ONFIGURATION
After the above configuration, execute the
the running of the SNMP configuration, and to verify the effect of the configuration.
Execute the debugging command in User View to debug SNMP configuration.
Table 631 Display and Debug SNMP
Operation
Display the modules with trap enabled
and the module with trap not enabled
Display the statistics information about
SNMP packets
Display the engine ID of the active device
Display the group name, the security
mode, the states for all types of views,
and the storage mode of each group of
the Switch.
Display the names of all users in the group
user table
Display the current community name
Display the current MIB view
Display the contact character string of the
system
Display the location character string of the
system
Display the version character string of the
system
Networking Requirements
Network Management Station and the Switch are connected using the Ethernet. The
IP address of Network Management Station is 129.102.149.23 and that of the VLAN
interface on the Switch is 129.102.0.1. Perform the following configurations on the
Switch: set the community name and access authority, administrator ID, contact and
Switch location, and enable the Switch to send trap packet.
Networking Diagram
Figure 166 SNMP Configuration Example
129.102.149.23
NMS
Ethernet
display
Command
display snmp-agent trap-list
display snmp-agent statistics
display snmp-agent { local-engineid |
remote-engineid }
display snmp-agent group [ group-name ]
display snmp-agent usm-user [ engineid
engineid ] [ group groupname ] [
username username ]
display snmp-agent community [ read |
write ]
display snmp-agent mib-view [ exclude
| include | viewname mib-view ]
display snmp-agent sys-info contact
display snmp-agent sys-info location
display snmp-agent sys-info version
129.102.0.1
command in all views to display