Displaying And Debugging Ethernet Port - 3Com 5500-SI Configuration Manual

66 C 3: P O
HAPTER ORT PERATION
Displaying and
Debugging Ethernet
Port
statistics. The VLAN setting includes permitted VLAN types, and default VLAN ID. The
port setting includes port link type, port speed, and duplex mode. LACP setting
includes LACP enabling/disabling.
Perform the following configuration in System View.
Table 48 Copying Port Configuration to Other Ports
Operation Command
Copy port copy configuration source { interface_type
configuration to interface_number | interface_name | aggregation_group
other ports agg_id } destination { interface_list [
aggregation_group agg_id ] | aggregation_group agg_id }
Note that if the copy source is an aggregation group, take the port with minimum ID
as the source; if the copy destination is an aggregation group, make the
configurations of all group member ports identical with that of the source.
After the above configuration, enter the
running of the Ethernet port configuration, and to verify the effect of the
configuration.
Enter the command in User View to clear the statistics information of the port.
reset
Enter the command in Ethernet Port View to check whether the Ethernet
loopback
port works normally. In the process of the loopback test, the port cannot forward any
packets. The loop test will finish automatically after a short time.
Table 49 Displaying and Debugging Ethernet Port
Operation
Perform loopback test on the Ethernet
port.
Display all port information
Display port information of a specific unit display unit unit_id interface
Display hybrid port or trunk port
Display the state of loopback detection on
the port.
Clear statistics information of the port
Note that:
The loopback test cannot be performed on a port disabled by the
■
command. During the loopback test, the system will disable
and operation on the port. Some ports do not support the loopback
shutdown
test. If performing this command in these ports, you will see the system prompt.
After 802.1X is enabled, the port information cannot be reset.
■
command in any view to display the
display
Command
loopback { external | internal }
display interface { interface_type |
interface_type interface_num |
interface_nam }
display port { hybrid | trunk }
display loopback-detection
reset counters interface [
interface_type | interface_type
interface_num | interface_name ]
shutdown
, ,
speed duplex mdi