Setting Attributes Of The Local User - 3Com 5500-SI Configuration Manual

Setting Attributes of the
Local User
The attributes of a local user include its password display mode, state, service type
and some other settings.
Setting the Password Display Mode
Perform the following configurations in System View.
Table 447 Setting the Password Display Mode of Local Users
Operation
Set the password display mode of
local users
Cancel the configuration of
password display mode
means that the password display mode will be the one specified by the user at
auto
the time of configuring the password (see the
reference), and
cipher-force
accessing users must be in cipher text.
Setting the Attributes of Local Users
Perform the following configurations in Local User View.
Table 448 Setting/Removing the Attributes Concerned with a Specified User
Operation
Set a password for a specified user
Remove the password set for the
specified user
Set the state of the specified user
Set a priority level for the user
Restore the default priority level
Set a service type for the specified
user
Cancel the service type of the
specified user
Configure the attributes of
lan-access users
Remove the attributes defined for
the lan-access users
Note the following two items when you configure these service types: SSH, Telnet or
Terminal.
When you configure a new service type for a user, the system adds the requested
■
service-type to any existing configuration. For example, if the user previously had
just Telnet access, and SSH was added, the user would now have access to both
Telnet and SSH.
You can set user level when you configure a service type. If you set multiple service
■
types and specify the user levels, then only the last configured user level is valid.
Some of the service types allow a user-privilege level to be entered as an optional
extra parameter. For example Telnet, Terminal and SSH.
Command
local-user password-display-mode {
cipher-force | auto }
undo local-user password-display-mode
password
means that the password display mode of all the
Command
password { simple | cipher } password
undo password
state { active | block }
level level
undo level
service-type { ftp [ ftp-directory
directory ] | lan-access | { ssh | telnet |
terminal }* }
undo service-type { ftp [ ftp-directory ]
| lan-access | { ssh | telnet | terminal
}* [ level level ] }
attribute { ip ip_address | mac mac_address
| idle-cut second | access-limit
max_user_number | vlan vlanid | location {
nas-ip ip_address port portnum | port
portnum } }*
undo attribute { ip | mac | idle-cut |
access-limit | vlan | location }*
Dynamic VLAN Assignment 419
command in Table 448 for