Setting Lifetime Of Trap Message; Setting Snmp System Information; Setting The Engine Id Of A Local Or Remote Device; Setting/Deleting An Snmp Group - 3Com 5500-SI Configuration Manual

Setting Lifetime of Trap
Message
Setting SNMP System
Information
Setting the Engine ID of
a Local or Remote
Device
Setting/Deleting an
SNMP Group
You can use the following command to set the lifetime of a Trap message. A trap
message that exists longer than the set lifetime will be dropped.
Perform the following configuration in System View.
Table 620 Set the Lifetime of Trap Message
Operation
Set lifetime of Trap message
Restore lifetime of Trap message
By default, the lifetime of Trap message is 120 seconds.
The SNMP system information includes the character string sysContact (system
contact), the character string describing the system location, the version information
about the SNMP operating in the system.
You can use the following commands to set the system information.
Perform the following configuration in System View.
Table 621 Set SNMP System Information
Operation
Set SNMP System Information
Restore the default SNMP System
Information of the Switch
By default, the sysLocation is specified as a blank string, that is, "".
You can use the following commands to set the engine ID of a local or remote device.
Perform the following configuration in System View.
Table 622 Set the Engine ID of a Local or Remote Device
Operation
Set the engine ID of the device
Restore the default engine ID of the device. undo snmp-agent local-engineid
By default, the engine ID is expressed as enterprise No. + device information. The
device information can be IP address, MAC address, or user-defined text.
You can use the following commands to set or delete an SNMP group.
Perform the following configuration in System View.
SNMP Configuration Introduction 567
Command
snmp-agent trap life seconds
undo snmp-agent trap life
Command
snmp-agent sys-info { contact sysContact |
location syslocation | version { { v1 | v2c |
v3 } * | all } }
undo snmp-agent sys-info [ { contact |
location }* | version { { v1 | v2c | v3 }* |
all } ]
Command
snmp-agent local-engineid engineid