Configuring Profile Application Mode - 3Com 5500-SI Configuration Manual

Configuring Profile
Application Mode
Perform the following configuration in System View.
Table 393 Entering QoS Profile View
Operation
Enter QoS profile view
Delete the QoS profile
You cannot delete the specific QoS profile which has been applied to the port.
Adding/Removing Traffic Action to a QoS Profile
From the QoS Profile View, you can configure the QoS actions for current QoS profile.
The maximum action numbers in one QoS profile is 32.
Perform the following configuration in QoS Profile View.
Table 394 Adding/Removing Traffic Action to QoS Profile
Operation Command
Add packet filtering
packet-filter { inbound | outbound } { user-group
action
acl_number [ rule rule ] | ip-group acl_number [ rule
rule [ link-group acl_number rule rule ] ] |
link-group acl_number [ rule rule ] }
Add traffic policing
traffic-limit inbound { user-group acl_number [ rule
action
rule ] | ip-group acl_number [ rule rule [ link-group
acl_number rule rule ] ] | link-group acl_number [
rule rule ] } target_rate [ exceed action ]
Add preference
traffic-priority { inbound | outbound } { user-group
replacing action
acl-number [ rule rule ] | ip-group acl_number [ rule
rule [ link-group acl_number rule rule ] ] |
link-group acl-number [ rule rule ] } { { dscp
dscp_value | ip-precedence { pre_value | from-cos }
} | { pre_value | from-ipprec } | local-precedence
pre_value }*
Remove packet
undo packet-filter { inbound | outbound } {
filtering action
user-group acl_number [ rule rule ] | ip-group
acl_number [ rule rule [ link-group acl_number rule
rule ] ] | link-group acl_number [ rule rule ] }
Remove traffic policing
undo traffic-limit inbound { user-group acl_number [
action
rule rule ] | ip-group acl_number [ rule rule [
link-group acl_number
acl_number [ rule rule ] }
Remove preference
undo traffic-priority { inbound | outbound } {
replacing action
user-group acl_number [ rule rule ] | ip-group
acl_number [ rule rule [ link-group acl_number
rule ] ] | link-group acl_number [ rule rule ] }
You cannot remove the packet filtering, traffic policing or preference replacing action
from the QoS profile which has been applied to the port.
After you configure the QoS profiles and the user passes the authentication, the
Switch will deliver the right profile dynamically to the port from which the user is
accessed. The QoS profile can be delivered to the port in these different modes:
User-based mode: If the source station information (source MAC address, source IP
■
address or source MAC address + IP address) has been defined in the ACL which is
referenced in the traffic actions, the Switch cannot deliver the QoS profile; if no
source station information is available, the Switch generates a new ACL by adding
the source MAC address into the existing ACL, and then delivers all traffic actions
in the QoS profile to the user port.
Command
qos-profile profile-name
undo qos-profile profile-name
rule rule ] ] | link-group
QoS Profile Configuration 373
rule