Specifying The Stacking Vlan Of The Switch; Setting Unit Ids For Switches - 3Com 5500-SI Configuration Manual

80 C 4: XRN C
HAPTER ONFIGURATION
Specifying the Stacking
VLAN of the Switch
Setting Unit IDs for
Switches
Table 60 Configuring FTM
Device Configuration
Switch Specify the stacking
VLAN of the Switch
Set unit IDs for the
Switches
Specify the Fabric
port of the Switch
Set unit names for
the Switches
Set a name for the
Fabric where the
Switches belong
Set the
authentication
mode for the Fabric
The Switch 5500 Series: the SI units supports basic XRN, that is, Distributed Device
Management (DDM) and Distributed Link Aggregation (DLA); the EI units support
enhanced XRN, that is DDM, Distributed Resilient Routing (DRR).
You can use the command in the following table to specify the
Switch.
Perform the following configuration in System View.
Table 61 Specifying the
Operation

Specifying the stacking VLAN of the Switch

Setting the stacking VLAN of the Switch to Default Value undo ftm stacking-vlan
By default, the stacking VLAN is VLAN 4093.
You should specify the stacking VLAN before the Fabric is established.
You can use the command in the following table to set unit IDs for Switches. Make
sure to set different unit IDs for different Switches in a Fabric. On the Switches that
support auto numbering, FTM will automatically number the Switches to constitute a
Fabric, so that each Switch has a unique unit ID in the Fabric.
Perform the following configuration in System View.
Table 62 Setting unit IDs for Switches
Operation
Set unit IDs for Switches
If the modified unit ID does not exist in the Fabric, the Switch sets its priority to 5
n
and saves it in the unit Flash memory.
Default Settings Comment
The stacking
VLAN is VLAN
4093
The unit ID of a
Switch is set to 1
-
-
The Fabric name
of the Switches is
5500
No authentication
mode is set on the
Switches
VLAN of the Switch
Stacking
Command
change unit-id <1-8> to {<1-8> |
auto-numbering }
You should specify the stacking
VLAN before the Fabric is
established.
Make sure that you have set
different unit IDs to different
Switches, so that the Fabric can
operate normally after all the
Switches are interconnected.
For 28-port Switch, the 27
port can be the Fabric port, for
52-port Switch, the 51 st , 52
can be the Fabric port.
-
Interconnected the Switches with
the same Fabric name to form a
Fabric.
Set the same authentication mode
on all the devices within the Fabric.
VLAN of the
stacking
Command
ftm stacking-vlan vlan-id
th th
28
nd port