3Com 5500-SI Configuration Manual page 231

Perform the following configurations in RIP View.
Table 214 Configuring the Default Cost for the Imported Route
Operation
Configure default cost for the imported route
Restore the default cost of the imported route
By default, the cost
value
Setting the RIP Preference
Each routing protocol has its own preference by which the routing policy selects the
optimal route from the routes of different protocols. The greater the preference value,
the lower the preference. The preference of RIP can be set manually.
Perform the following configurations in RIP View.
Table 215 Setting the RIP Preference
Operation
Set the RIP Preference
Restore the default value of RIP preference
By default, the preference of RIP is 100.
Setting Additional Routing Metrics
The additional routing metric is the input or output routing metric added to an RIP
route. It does not change the metric value of the route in the routing table, but adds
a specified metric value when the interface receives or sends a route.
Perform the following configuration in Interface View:
Table 216 Setting Additional Routing Metrics
Operation
Set the additional routing metric of the route when the
interface receives an RIP packet
Disable the additional routing metric of the route when the
interface receives an RIP packet
Set the additional routing metric of the route when the
interface sends an RIP packet
Disable the additional routing metric of the route when the
interface sends an RIP packet
By default, the additional routing metric added to the route when RIP sends the
packet is 1. The additional routing metric when RIP receives the packet is 0.
The metricout configuration takes effect only on the RIP routes learnt by the router
and RIP routes generated by the router itself, which means that it has no effect on the
routes imported to RIP by other routing protocols.
Configuring Route Filtering
The Router provides a route filtering function. You can configure the filter policy rules
by specifying the ACL and ip-prefix for route redistribution and distribution. To import
a route, the RIP packet of a specific router can also be received by designating a
neighbor router.
Command
default cost value
undo default cost
for the RIP imported route is 1.
Command
preference value
undo preference
RIP 231
Command
rip metricin value
undo rip metricin
ip metricout value
undo rip metricout