Displaying And Debugging User Interface - 3Com 5500-SI Configuration Manual

auto-execute command The following command is used to automatically run a
command after you log in. After a command is configured to be run automatically, it
will be automatically executed when you log in again.
This command is usually used to automatically execute the
terminal, which will connect the user to a designated device automatically.
Perform the following configuration in User Interface View.
Table 28 Configuring to Automatically Run the Command
Operation
Configure to automatically run the command
Configure not to automatically run the
command
Note the following points:
■
■
Telnet 10.110.100.1 after the user logs in through VTY0 automatically.
[SW5500-ui-vty0]auto-execute command telnet 10.110.100.1
When a user logs on through VTY 0, the system will run
automatically.
Displaying and After the above configuration, use the
Debugging User running of the user interface configuration, and to verify the effect of the
Interface configuration.
Use the
Table 29 Displaying and Debugging User Interface
Operation
Clear a specified user interface
Display the user application information
of the user interface
Display the physical attributes and some
configurations of the user interface
After executing this command, the user interface can no longer be used to carry
out the routine configurations for the local system. Use this command with
caution.
Make sure that you will be able to log in the system in another way and cancel the
configuration, before you use the
configuration.
command in User View to clear a specified user interface.
free
User Interface Configuration
telnet
Command
auto-execute command text
undo auto-execute command
auto-execute command
telnet
command in any view to display the
display
Command
free user-interface [ type ] number
display users [ all ]
display user-interface [ type number |
number ] [ summary ]
49
command on the
command and save the
10.110.100.1