Traffic Sharing Across Rip Interfaces; Displaying And Debugging Rip; Example: Typical Rip Configuration - 3Com 5500-SI Configuration Manual

Traffic Sharing Across
RIP Interfaces
Displaying and
Debugging RIP
Example: Typical RIP
Configuration
Equal-cost routes are routes with the same destination but different next hop
addresses in a routing table. After traffic sharing across RIP interfaces is enabled, the
system averagely distributes the traffic to its RIP interfaces through equal-cost routes.
Configuration Procedure
You can perform the following operations to configure traffic sharing across RIP
interfaces.
Table 219 Configure traffic sharing across RIP interfaces
Operation
Enter system view
Enter RIP view
Enable traffic sharing across RIP
interfaces
Display the current running
state and configuration
information of the RIP protocol
After configuring RIP, enter the
configuration, and to verify the effect of the configuration. Enter the
command in User View to debug the RIP module. Enter the
View to reset the system configuration parameters of RIP.
Table 220 Displaying and Debugging RIP
Operation
Display the current RIP running state and
configuration information
Enable the RIP debugging information
Disable the RIP debugging information
Enable the debugging of RIP receiving packet
Disable the debugging of RIP receiving packet
Enable the debugging of RIP sending packet
Disable the debugging of RIP sending packet
Reset the system configuration parameters of RIP
Display Command for RIP Interfaces
Use the command display rip interface to display information about RIP interfaces.
Networking Requirements
As shown in Figure 55, Switch C connects to the subnet 117.102.0.0 through the
Ethernet port. The Ethernet ports of Switch A and Switch B are connected to the
networks 155.10.1.0 and 196.38.165.0 respectively. Switch C, Switch A and Switch B
are connected using Ethernet 110.11.2.0. Correctly configure RIP to ensure that
Switch C, Switch A and Switch B can interconnect.
Command
system-view
rip
traffic-share-across-interface
display rip
command in any view to display the RIP
display
Command
display rip
debugging rip packet
undo debugging rip packet
debugging rip receive
undo debugging rip receive
debugging rip send
undo debugging rip send
reset
RIP 233
Description
-
-
Required
By default, traffic sharing across
RIP interfaces is disabled.
You can execute this command
in any view.
debugging
command in RIP
reset