Clustering Configuration Example - 3Com 5500-SI Configuration Manual

610 C 32: C
HAPTER LUSTERING
Clustering
Configuration
Example
Network requirements
Three switches form a cluster, in which:
Switch 5500 acts as the management device.
■
Other two switches act as member devices.
■
As the management device, Switch 5500 manages the member devices and is
configured as follows:
It attaches two member devices through ports Ethernet1/0/2 and Ethernet1/0/3
■
respectively.
It connects with the external network through port Ethernet1/0/1.
■
Ethernet1/0/1 belongs to VLAN2, whose interface IP address is 163.172.55.1.
■
The same FTP server and TFTP server is used through the cluster.
■
The IP address of the FTP server and TFTP server is 63.172.55.1.
■
The IP address of the SNMP site and logging host is 69.172.55.4.
■
Network diagram
Cluster Management
FTP server/ TFTP server FTP server/ TFTP server
63.172.55.1 63.172.55.1
Configuration procedure
1 Configure the management device
a Enable system NDP and port NDP on E1/0/2 and E1/0/3.
[S5500] ndp enable
[S5500] interface ethernet 1/0/2
[S5500-Ethernet1/0/2] ndp enable
[S5500-Ethernet1/0/2] interface ethernet 1/0/3
[S5500-Ethernet1/0/3] ndp enable
Network Network
Management Management
device device
E1/0/ 3 E1/0/ 3
E1/1 E1/1
Cluster Cluster
Member device MAC address Member device MAC address Member device MAC address Member device MAC address
00e0. fc01.0011 00e0. fc01.0011
SNMP host/logging host SNMP host/logging host
69.172.55.4 69.172.55.4
E1/0/1 E1/0/1
VLAN2 interface IP address VLAN2 interface IP address
163.172.55.1 163.172.55.1
E1/0/2 E1/0/2
E1/1 E1/1
00e0. fc01.0012 00e0. fc01.0012