3Com 5500-SI Configuration Manual page 44

44 C 1: G
HAPTER ETTING
S
TARTED
Configuring the Attributes of AUX (Console) Port
Use the ,
speed flow control
configure these attributes of the AUX (console) port.
Perform the following configurations in User Interface (AUX user interface only) View.
Configuring the Transmission Speed on the AUX (Console) Port
Table 12 Configuring the Transmission Speed on the AUX (Console) Port
Operation
Configure the transmission speed on the AUX
(console) port
Restore the default transmission speed on the AUX
(console) port
By default, the transmission speed on
Configuring the Flow Control on the AUX (Console) Port
Table 13 Configuring the Flow Control on the AUX (Console) Port
Operation
Configure the flow control on the AUX (console) port flow-control { hardware | none
Restore the default flow control mode on the AUX
(console) port
By default, the flow control on the AUX (console) port is none, that is, no flow control
will be performed.
Configuring Parity on the AUX (Console) Port
Table 14 Configuring Parity on the AUX (Console) Port
Operation
Configure parity mode on the AUX (console)
port
Restore the default parity mode
By default, the parity on the AUX (console) port is none, that is, no parity bit.
Configuring the Stop Bit of AUX (Console) Port
Table 15 Configuring the Stop Bit of AUX (Console) Port
Operation
Configure the stop bit of the AUX (console) port
Restore the default stop bit of the AUX (console) port undo stopbits
By default, the AUX (console) port supports 1 stop bit.
Configuring the Data Bit of the AUX (Console) port
Table 16 Configuring the Data Bit of the AUX (Console) Port
Operation
Configure the data bit of the AUX (console) port
Restore the default data bit of the AUX (console) port
By default, the AUX (console) port supports 8 data bits.
, , , and
parity stop bit
Command
speed speed_value
undo speed
AUX (console) port is 9600bps.
the
Command
| software }
undo flow-control
Command
parity { even | mark | none | odd |
space }
undo parity
Command
stopbits { 1 | 1.5 | 2 }
Command
databits { 7 | 8}
undo databits
commands to
data bit