Displaying And Debugging Of Voice Vlan; Voice Vlan Configuration Example - 3Com 5500-SI Configuration Manual

106 C 6: VLAN O
HAPTER
Displaying and
Debugging of Voice
VLAN
Voice VLAN
Configuration Example
PERATION
After completing the above configuration, enter the
to view the configuration and running state of Voice VLAN.
Table 97 Displaying Voice VLAN
Operation
Display the status of Voice VLAN
Display the OUI address supported by the current system
Networking Requirements
Create VLAN 2 as the Voice VLAN in manual mode and enable its security mode. It is
required to set the aging time to 100 minutes, the OUI address to 0011-2200-0000,
and configure the port Ethernet1/0/2 as the IP Phone access port. The type of IP
Phone is untagged.
Network Diagram
Figure 25 Voice VLAN Configuration
Configuration Steps
[SW5500]vlan 2
[SW5500-vlan2]port ethernet1/0/2
[SW5500-vlan2]interface ethernet1/0/2
[SW5500-Ethernet1/0/2]voice vlan enable
[SW5500 -Ethernet1/0/2]quit
[SW5500]undo voice vlan mode auto
[SW5500]voice vlan mac_address 0011-2200-0000 mask ffff-ff00-0000
description private
[SW5500]voice vlan 2 enable
[SW5500]voice vlan aging 100
command in any view
display
Command
display voice vlan status
display voice vlan oui