Aaa And Radius Protocol Configuration Example - 3Com 5500-SI Configuration Manual

AAA and RADIUS
Protocol Configuration
Example
Table 470 Displaying and Debugging AAA and RADIUS Protocol (continued)
Operation
Clear stop-accounting packets from the
buffer.
Reset the statistics of RADIUS server.
Enable RADIUS packet debugging
Disable RADIUS packet debugging
Enable debugging of localRADIUS scheme
Disable debugging of localRADIUS scheme
For the hybrid configuration example of AAA/RADIUS protocol and 802.1x protocol,
refer to "802.1x Configuration Example" on page 403.
Configuring the FTP/Telnet User Authentication at a Remote RADIUS Server
Configuring Telnet user authentication at the remote server is similar to configuring
FTP users. The following description is based on Telnet users.
Networking Requirements
In Figure 110, it is required to configure the remote RADIUS authentication of Telnet
users.
One RADIUS server (as authentication server) is connected to the Switch and the
server IP address is 10.110.91.146. The password for exchanging messages between
the Switch and the authentication server is "expert". The Switch cuts off the domain
name from username and sends the remaining part to the RADIUS server.
Networking Topology
Figure 110 Configuring the Remote RADIUS Authentication for Telnet Users
telnet user
User Re-authentication at Reboot 431
Command
reset stop-accounting-buffer {
radius-scheme radius_scheme_name |
session-id session_id | time-range
start_time stop_time | user-name
user_name }
reset radius statistics
debugging radius packet
undo debugging radius packet
debugging local-server { all | error
| event | packet }
undo debugging local-server { all |
error | event | packet }
Authentication Servers
( IP address:10.110.91.164 )
Switch
Internet Internet