234
C
16: IP R
HAPTER
OUTING
Troubleshooting RIP
P
O
ROTOCOL
PERATION
Networking Diagram
Figure 55 RIP configuration networking
Ethernet
SwitchC
Interface address:
117.102.0.1/16
Network address:
117.102.0.0/16
Configuration Procedure
The following configuration only shows the operations related to RIP. Before
performing the following configuration, please make sure the Ethernet link layer can
work normally.
1 Configure RIP on Switch A
[Switch A]rip
[Switch A-rip]network 110.11.2.0
[Switch A-rip]network 155.10.1.0
2 Configure RIP on Switch B
[Switch B]rip
[Switch B-rip]network 196.38.165.0
[Switch B-rip]network 110.11.2.0
3 Configure RIP on Switch C
[Switch C]rip
[Switch C-rip]network 117.102.0.0
[Switch C-rip]network 110.11.2.0
The Switch 5500 cannot receive the update packets when the physical connection to
the peer routing device is normal.
RIP does not operate on the corresponding interface (for example, the
■
command is executed) or this interface is not enabled through the
work
command.
The peer routing device is configured to be in the multicast mode (for example,
■
the
rip version 2 multicast
not been configured on the corresponding interface of the local Ethernet Switch.
Network address:
155.10.1.0/24
Interface address:
155.10.1.1/24
SwitchA
Interface address:
110.11.2.1/24
Interface address:
196.38.165.1/24
command is executed) but the multicast mode has
Network address:
110.11.2.2/24
SwitchB
Network address:
196.38.165.0/24
undo rip
network