Sending The Information To Telnet Terminal Or Dumb Terminal - 3Com 5500-SI Configuration Manual

478 C 22: F S
HAPTER ILE YSTEM
Sending the Information
to Telnet Terminal or
Dumb Termina
M
ANAGEMENT
Perform the following operation in User View:
Table 537 Enabling Terminal Display Function
Operation
Enable terminal display function of debugging
information
Disable terminal display function of debugging
information
Enable terminal display function of log information
Disable terminal display function of log information
Enable terminal display function of trap information
Disable terminal display function of trap information
To send information to a Telnet terminal or dumb terminal, follow the steps below:
l
1 Enabling info-center
Perform the following operation in System View.
Table 538 Enable/Disable Info-Center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system performances
are affected when the system processes much information because of information
classification and outputting.
2 Configuring to output information to Telnet terminal or dumb terminal
Perform the following operation in System View.
Table 539 Configuring to Output Information to Telnet Terminal or Dumb Terminal
Operation
Output information to Telnet terminal or dumb
terminal
Cancel the configuration of outputting
information to Telnet terminal or dumb terminal
3 Configuring information source on the Switch
With this configuration, you can define the information that is sent to the Telnet
terminal or dumb terminal that is generated by which modules, information type,
information level, and so on.
Perform the following operation in System View:
Table 540 Defining Information Source
Operation
Define information source info-center source { modu-name | default } channel
Cancel the configuration
of information source
Command
info-center enable
undo info-center enable
Command
info-center monitor channel {
channel-number | channel-name }
undo info-center monitor channel
Command
{ channel-number | channel-name } [ { log | trap |
debug }* { level severity | state state }* ]
undo info-center source { modu-name | default }
channel { channel-number | channel-name }
Command
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging
terminal trapping
undo terminal trapping