Configuring
Internal-External
Interaction
NM Interface for Cluster
Management
Configuration
Table 661 Configure cluster parameters manually (continued)
Operation
Command
Configure VLAN check
port-tagged management-vlan
on the management
device for the
communication inside
a cluster
Exit system view
quit
Configuring a cluster Automatically
Table 662 Configure a cluster automatically
Operation
Enter system view
Configure a cluster
automatically
Table 663 Configure internal-external interaction
Operation
Enter system view
Enter cluster view
Configure an FTP server for
the cluster
Configure a TFTP server for
the cluster
Configure a log host for the
cluster
Configure an SNMP host for
the cluster
Configuration Preparation
The cluster switches are properly connected.
■
The internal server is properly connected with the management switch.
■
Configuration Procedure
Table 664 Configuration procedure
Step
Enter system view
Enter cluster view
Configure the NM interface
Display information about
current configuration
Management Device Configuration 607
Command
system-view
auto-build [ recover ]
Command
system-view
cluster
ftp-server ip-address
tftp-server ip-address
logging-host ip-address
snmp-host ip-address
Command
system-view
cluster
nm-interface Vlan-interface
vlan_id
display
current-configuration
Remark
Optional
—
Remark
—
Required
This is to set up a cluster based on
your instructions.
Description
—
Required
Optional
Optional
Optional
Optional
Description
Required
vlan_id: VLAN ID
You can execute this command in
any view.