3Com 5500-SI Configuration Manual page 140

140 C 10: DHCP S
HAPTER
C
ERVER ONFIGURATION
Configuring the option 184 supporting function in system view
Table 129 Configure the option 184 supporting function in system view
Operation
Enter system view
Configure the interface to
operate in DHCP server
mode and assign the IP
addresses of a specified
interface-based address pool
to DHCP clients
Configure the NCP-IP
sub-option
Configure the AS-IP
sub-option
Configure the voice VLAN
configuration sub-option
Configure the Fail-over
routing sub-option
Enter the corresponding
interface view
Configure an IP address for
the interface
Perform the operations listed in Table 129 if you specify to assign IP addresses of an
interface-based address pool to DHCP clients.
This method allows you to configure the option 184 supporting function for multiple
interfaces.
Command
system-view
dhcp select interface { all | interface
interface-type interface-number [ to
interface-type interface-number ] }
dhcp server voice-config ncp-ip
ip-address { all | interface
interface-type interface-number [ to
interface-type interface-number ] }
dhcp server voice-config as-ip
ip-address { all | interface
interface-type interface-number [ to
interface-type interface-number ] }
dhcp server voice-config voice-vlan
vlan-id { enable | disable } { all |
interface interface-type
interface-number [ to interface-type
interface-number ] }
dhcp server voice-config fail-over
ip-address dialer-string { all | interface
interface-type interface-number [ to
interface-type interface-number ] }
interface interface-type
interface-number
ip address ip-address net-mask
Description
-
Required
Required
Optional
You can configure these
three sub-options only
after you configure the
NCP-IP sub-option.
To create an
interface-based address
pool, you need to
configure an IP address for
the interface.