Sending The Information To The Log Buffer - 3Com 5500-SI Configuration Manual

480 C 22: F S
HAPTER ILE YSTEM
Sending the Information
to the Log Buffer
M
ANAGEMENT
Operation
Disable terminal display function of trap information
To send information to the log buffer, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 543 Enabling/Disabling Info-center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system performances
are affected when the system processes much information because of information
classification and outputting.
2 Configuring to output information to the log buffer
Perform the following operation in System View.
Table 544 Configuring to Output Information to Log Buffer
Operation
Output information to log buffer
Cancel the configuration of
outputting information to log buffer
3 Configuring the information source on the Switch
With this configuration, you can define the information that is sent to the log buffer:
generated by which modules, information type, information level, and so on.
Perform the following operation in System View:
Table 545 Defining the Information Source
Operation Command
Define information
info-center source { modu-name | default } channel {
source
channel-number | channel-name } [ { log | trap | debug
}* { level severity | state state }* ]
Cancel the
undo info-center source { modu-name | default } channel
configuration of
{ channel-number | channel-name }
information source
specifies the module name;
modu-name
refers to the severity levels;
information with the level below it will not be output.
channel number and
When defining the information sent to the log buffer,
must be set to the channel that corresponds to the Console direction.
channel-name
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there is
no specific configuration record for a module in the channel, use the default one.
Command
info-center enable
undo info-center enable
Command
info-center logbuffer [ channel {
channel-number | channel-name } ] [ size
buffersize ]
undo info-center logbuffer [ channel |
size ]
default
specifies the severity level of information. The
severity
specifies the channel name.
channel-name
Command
undo terminal trapping
represents all the modules;
channel-number
or
channel-number
level
specifies the
default