Configuring A User Login Password In Encryption Mode; Configuring Login Attempts Limitation And Failure Processing Mode - 3Com 5500-SI Configuration Manual

580 C 30: P
HAPTER ASSWORD
Configuring a User Login
Password in Encryption
Mode
Configuring Login
Attempts Limitation and
Failure Processing Mode
C C O
ONTROL ONFIGURATION PERATIONS
Table 639 Configuring a user login password in encryption mode
Operation
Enter system view
Enter the specified user
view
Configure a user login
password in encryption
mode
Table 640 Configure the login attempts limitation and the failure processing mode
Operation
Enter system view
Enable the login attempts
limitation, configure the
maximum number of
attempts and configure the
processing mode used
when the maximum
number of attempts is
exceeded.
View the user information
in the blacklist
When the maximum number of attempts is exceeded, the system operates in one of
the following processing mode:
locktime: In this mode, the system inhibits the user from re-logging in within a
■
certain time period. After the period, the user is allowed to log into the switch
again. By default, this time is 120 minutes.
lock: In this mode, the system inhibits the user from re-logging in forever. The user
■
is allowed to log into the switch again only after the administrator removes the
user from the user blacklist.
unlock: In this mode, the system allows the user to log in again.
■
No inhibition operation is performed for the users who execute the Super command
but fail to log in using the password.
If a user in the blacklist changes his/her IP address, the blacklist will not affect the user
any more when the user logs into the switch.
Command
system-view
ocal-user username
l
password
Command
system-view
password-control
login-attempt login-times [
exceed { lock | unlock | locktime
time } ]
display password-control blacklist
Description
—
—
Optional
Input a password according to
the system prompt and ensure
the two input passwords are
consistent.
Description
—
Optional
By default, the maximum
number of attempts is three,
and the switch operates in the
locktime processing mode
when the maximum number of
attempts is exceeded.
Optional
You can use the display
command in any view