3Com 5500-SI Configuration Manual page 479

specifies the module name;
modu-name
refers to the severity levels;
information with the level below it will not be output.
channel number and
When defining the information sent to Telnet terminal or dumb terminal,
or
channel-number channel-name
the Console direction.
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there is
no specific configuration record for a module in the channel, use the default one.
When there are more than one Telnet users or monitor users at the same time, some
configuration parameters should be shared among the users, such as module-based
filtering settings and severity threshold. When a user modifies these settings, it will be
reflected on other clients.
If you want to view the debugging information of some modules on the Switch, you
must select
debugging
meantime using the
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View.
Table 541 Configuring the Output Format of Time-stamp
Operation
Configure the output format of the
time-stamp
Output time-stamp is disabled
4 Enabling terminal display function
To view the output information at the Telnet terminal or dumb terminal, you must first
enable the corresponding log, debugging and trap information functions at the
Switch.
For example, if you have set the log information as the information sent to the Telnet
terminal or dumb terminal, you need to use the
enable the terminal display function of log information on the Switch, then you can
view the information at the Telnet terminal or dumb terminal.
Perform the following operation in User View.
Table 542 Enabling Terminal Display Function
Operation
Enable terminal display function of log, debugging and trap
information
Disable terminal display function of the above information
Enable terminal display function of debugging information
Disable terminal display function of debugging information
Enable terminal display function of log information
Disable terminal display function of log information
Enable terminal display function of trap information
default
specifies the severity level of information. The
severity
specifies the channel name.
channel-name
must be set to the channel that corresponds to
as the information type when configuring information source,
command to turn on the debugging Switch of those
debugging
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
Logging Function 479
represents all the modules;
channel-number
command to
terminal logging
Command
terminal monitor
undo terminal monitor
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging
terminal trapping
level
specifies the
default