System Debugging - 3Com 5500-SI Configuration Manual

462 C 22: F S
HAPTER ILE YSTEM

System Debugging

M
ANAGEMENT
Table 514 The Display Commands of the System (continued)
Operation
Display the current-configuration display current-configuration [ controller |
Display the state of the
debugging
Display statistics of the
configuration agent
Enable/Disable the Terminal Debugging
The Switch provides various ways for debugging most of the supported protocols and
functions, which can help you diagnose and address the errors.
The following Switches can control the outputs of the debugging information:
Protocol debugging Switch controls the debugging output of a protocol.
■
Terminal debugging Switch controls the debugging output on a specified user
■
screen.
Figure 121 illustrates the relationship between two Switches.
Figure 121 Debug Output
Debugging
information
Protocol debugging
switch
ON
Screen output switch
OFF
You can use the following commands to control the above-mentioned debugging.
Perform the following operations in User View.
Command
interface interface-type [ interface-number ]
| configuration [ configuration ] ] [ | {
begin | exclude | include }
regular-expression ]
display debugging [ interface {
interface-name | interface-type
interface-number } ] [ module-name ]
display config-agent unit-id unit-id
OFF ON
ON