Configuring Timers - 3Com 5500-SI Configuration Manual

398 C 21: 802.1
HAPTER

Configuring Timers

C
X ONFIGURATION
The following commands are used for configuring the 802.1x timers.
Perform the following configurations in System View.
Table 421 Configuring Timers
Operation
Configure timers
Restore default
settings of the timers
handshake-period:
After setting handshake-period, system will send the handshake packet by the period.
Suppose the dot1x retry time is configured as N, the system will consider the user
having logged off and set the user as logoff state if system doesn't receive the
response from user for consecutive N times.
handshake-period-value
units of second and defaults to 15.
: Specify the quiet timer. If an 802.1x user has not passed the
quiet-period
authentication, the Authenticator will keep quiet for a while (which is specified by
quiet-period
period, the Authenticator does not do anything related to 802.1x authentication.
quiet-period-value
to 120 in units of second and defaults to 60.
server-timeout
Authentication Server has not responded before the specified period expires, the
Authenticator will resend the authentication request.
server-timeout-value
Authentication Server is. The value ranges from 100 to 300 in units of second and
defaults to 100.
: Specify the authentication timeout timer of a user. After the
supp-timeout
Authenticator sends a Request/Challenge request packet to request the MD5
encrypted text, the supp-timeout timer of the Authenticator begins to run. If the user
does not respond back successfully within the time range set by this timer, the
Authenticator will resend the above packet.
supp-timeout-value
timer of a user is. The value ranges from 10 to 120 in units of second, and defaults to
30.
: Specify the transmission timeout timer. After the Authenticator sends a
tx-period
Request/Identity request packet which requests the user name, or the user name and
password together the tx-period timer of the Authenticator begins to run. If the user
does not respond back successfully with an authentication reply packet, then the
Authenticator will resend the authentication request packet.
tx-period-value
is. The value ranges from 10 to 120 in units of second, and defaults to 30.
Command
dot1x timer { { handshake-period
handshake-period-value | quiet-period
quiet_period_value | tx-period tx_period_value |
supp-timeout supp_timeout_value | server-timeout
server_timeout_value }
undo dot1x timer { handshake-period | quiet-period |
tx-period | supp-timeout | server-timeout }
This timer begins after the user has passed the authentication.
: Handshake period. The value ranges from 1 to 1024 in
timer) before launching the authentication again. During the quiet
: Specify how long the quiet period is. The value ranges from 10
: Specify the timeout timer of an Authentication Server. If an
: Specify how long the duration of a timeout timer of an
: Specify how long the duration of an authentication timeout
: Specify how long the duration of the transmission timeout timer