3Com 5500-SI Configuration Manual page 473

3 Sending the Information to monitor terminal
Table 525 Sending the Information to Monitor Terminal
Device Configuration
Switch Enable info-center
Set the information
output direction to
monitor
Set information
source
Enable the terminal
display function and
this function for the
corresponding
information
4 Sending the Information to log buffer.
Table 526 Sending the Information to Log Buffer
Device Configuration
Switch Enable info-center
Set the information output
direction to logbuffer
Set information source
5 Sending the Information to trap buffer.
Table 527 Sending the Information to Trap Buffer
Device Configuration
Switch Enable info-center
Set the information
output direction to
trapbuffer
Set information source
Default Value Configuration Description
By default, Other configurations are valid only if the
info-center is info-center is enabled.
enabled.
- -
- You can define which modules and
information to be sent out and the
time-stamp format of information, and so
on. You must turn on the Switch of the
corresponding module before defining
output debugging information.
- For Telnet terminal and dumb terminal, to
view the information, you must enable the
current terminal display function using the
terminal monitor command.
Default Value Configuration Description
By default, Other configurations are valid only if
info-center is the info-center is enabled.
enabled.
- You can configure the size of the log
buffer at the same time.
- You can define which modules and
information to be sent out and the
time-stamp format of information,
and so on. You must turn on the
Switch of the corresponding module
before defining output debugging
information.
Default Value Configuration Description
By default, info-center Other configurations are valid only if
is enabled. the info-center is enabled.
You can configure the size of the
trap buffer at the same time.
You can define which modules and
information to be sent out and the
time-stamp format of information,
and so on. You must turn on the
Switch of the corresponding module
before defining output debugging
information.
Logging Function 473