3Com 5500-SI Configuration Manual page 447

Displaying the Source IP Address of the FTP Client
Use the display command in any view to display the source IP address of the FTP client
for service packets.
Table 493 Display the source IP address of the FTP Client
Operation
Display the source IP address of the TFTP client
FTP Client Configuration Example
Networking Requirement
The Switch serves as the FTP client and the remote PC as the FTP server. The
configuration on the FTP server: Configure a FTP user named as Switch, with the
password hello and with read and write authority over the Switch root directory on
the PC. The IP address of a VLAN interface on the Switch is 1.1.1.1, and that of the
PC is 2.2.2.2. The Switch and PC are reachable.
The Switch application
download the
switch.app
the FTP server under the Switch directory for backup purpose.
Networking Diagram
Figure 113 Networking for FTP Configuration
S w itc h S w itc h S w itc h
Configuration Procedure
1 Configure the FTP server parameters on the PC: a user named as Switch, password
hello, read and write authority over the Switch directory on the PC.
2 Configure the Switch
Log into the Switch (locally through the Console port or remotely using Telnet).
<SW5500>
If the flash memory of the Switch is not enough, you need to first delete the existing
programs in the flash memory and then upload the new ones.
Type in the right command in User View to establish FTP connection, then correct
username and password to log into the FTP server.
<SW5500> ftp 2.2.2.2
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):switch
331 Give me your password, please
is stored on the PC. Using FTP, the Switch can
switch.app
from the remote FTP server and upload the
N e tw o rk N e tw o rk
FTP Overview 447
Command
display tftp source-ip
config.cfg
P C P C
to