HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 1234

Displaying SPAN Information
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
--------------------------------------------------------
Session
--------------------------------------------------------
7
1
2
Example 52-5 Displays a Specific SPAN Session in Detail
switch# show span session 7
Session 7 (active)
Destination is fc2/7
No session filters configured
No ingress (rx) sources
Egress (tx) sources are
Example 52-6 Displays ALL SPAN Sessions
switch# show span session
Session 1 (inactive as no destination)
Destination is not specified
Session filter vsans are 1
No ingress (rx) sources
No egress (tx) sources
Session 2 (active)
Destination is fc9/5
No session filters configured
Ingress (rx) sources are
No egress (tx) sources
Session 3 (admin suspended)
Destination is not configured
Session filter vsans are 1-20
Ingress (rx) sources are
Egress (tx) sources are
Example 52-7 Displays SPAN drop-counters for the SPAN Sessions
switch# show span drop-counters
SPAN Drop-Counters for module 3 is: 0x0
SPAN Drop-Counters for module 7 is: 0x0
Note
Example 52-8 Displays SPAN drop-threshold for the SPAN Sessions
switch# show span drop-threshold
Drop-Threshold for SPAN sessions: 15
Cisco MDS 9000 Family CLI Configuration Guide
52-16
Admin Oper
State State
no suspend active
suspend inactive
no suspend inactive
port-channel 7,
vsans 1
fc3/2, fc3/3, fc3/4, fcip 51,
port-channel 2, sup-fc0,
fc3/2, fc3/3, fc3/4, sup-fc0,
The show span drop-counters displays the dropped counters. You can configure the show span
drop-threshold only if the dropped counter value is greater than zero.
Chapter 52 Monitoring Network Traffic Using SPAN
Destination
Interface
fc2/7
not configured
fc3/1
OL-16184-01, Cisco MDS SAN-OS Release 3.x