HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 1239

Chapter 52 Monitoring Network Traffic Using SPAN
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
Creating VSAN Interfaces
Figure 52-10
Figure 52-10
source switch S
IP address of VSAN 5
interface = 10.10.10 1
This example assumes that VSAN 5 is already configured in the VSAN database.
Note
To create a VSAN interface in the source switch for the scenario in
Command
Step 1
switchS# config t
Step 2
switchS(config)# interface vsan 5
switchS(config-if)#
Step 3
switchS(config-if)# ip address 10.10.10.1
255.255.255.0
Step 4
switchS(config-if)# no shutdown
Enabling FC Tunnels
To enable the FC tunnel feature, follow these steps:
Command
Step 1
switchS# config t
Step 2
switchS(config)# fc-tunnel enable
Be sure to enable this feature in each switch in the end-to-end path in the fabric.
Note
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring the SD Port, page 52-25
Mapping the FC Tunnel, page 52-26
depicts a basic FC tunnel configuration.
FC Tunnel Configuration
Cisco MDS
FC tunnel source
FC tunnel 100
Cisco MDS
Fibre Channel
fabric
Purpose
Enters configuration mode.
Configures the specified VSAN interface (VSAN 5)
in the source switch (switch S).
Configures the IPv4 address and subnet for the
VSAN interface 5 in the source switch (switch S).
Enables traffic flow through this interface.
Purpose
Enters configuration mode.
Enables the FC tunnel feature (disabled by
default).
Cisco MDS 9000 Family CLI Configuration Guide
Remote SPAN
Cisco MDS
destination switch D
IP address of VSAN 5
interface = 10.10.10 2
Figure 52-10, follow these steps:
52-21