Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
5.1.4 spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision
Level is a number in the range of 0 to 65535.
Default
Format
Mode
5.1.4.1 no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value, i.e. 0.
Format
Mode
5.1.5 spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal
spanning tree. This allows this port to transition to Forwarding State without delay.
Format
Mode
5.1.5.1 no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format
Mode
5.1.6 spanning-tree edgeport all
This command specifies that every port is an Edge Port within the common and internal
spanning tree. This allows all ports to transition to Forwarding State without delay.
Format
Mode
Spanning Tree Protocol Commands
0
spanning-tree configuration revision <0-65535>
Global Config
no spanning-tree configuration revision
Global Config
spanning-tree edgeport
Interface Config
no spanning-tree edgeport
Interface Config
spanning-tree edgeport all
Global Config
v3.0, January 2008
5-3