Ip Rip Authentication; Ip Rip Receive Version - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

14.7.9 ip rip authentication

This command sets the RIP Version 2 Authentication Type and Key for the specified
interface. The value of <
authentication key [
displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value
of < > is
encrypt
type
interfaces do not need an authentication key or authentication key ID.
Default
Format
Mode
14.7.9.1 no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
Format
Mode

14.7.10 ip rip receive version

This command configures the interface to allow RIP control packets of the specified
version(s) to be received.
The value for <
for RIP version 2,
control packets to be received.
Default
Format
Mode
14.7.10.1 no ip rip receive version
This command configures the interface to allow RIP control packets of the default
version(s) to be received.
Format
Mode
Routing Commands
> is either
type
] must be 16 bytes or less. The [
key
, a keyid in the range of 0 and 255 must be specified
none
ip rip authentication {none | {simple <key>} |
{encrypt <key> <keyid>}}
Interface Config
no ip rip authentication
Interface Config
> is one of: to receive only RIP version 1 formatted packets,
rip1
mode
to receive packets from either format, or
both
both
ip rip receive version {rip1 | rip2 | both | none}
Interface Config
no ip rip receive version
Interface Config
v3.0, January 2008
, , or
none simple encrypt
] is composed of standard
key
. The value for
. Unauthenticated
rip2
to not allow any RIP
none
14-63