Table of Contents
Advertisement
You can associate more than one add-on image with a base image. Repeat this step for each
add-on image.
6 Click Apply.
When a device boots that is assigned to this bundle, the add-on images are put down after the
base image in the order listed on this page.
Using a File Set of an Image
As explained in
individual files and folders from any of 10 possible file sets of an image.
Table 30-1
Type of imaging
operation
Automatic
(Preboot
Services based
on default
settings)
Manual
(command line or
menu)
30.1.3 Setting Up Disconnected Imaging Operations
Disconnected imaging operations are inherently manual. To perform a disconnected imaging
operation on a device, you must have a storage device to hold the image to be created or put down,
and that storage device must be locally accessible to the ZENworks Imaging Engine (in Linux)
when you boot the device from the imaging boot media.
The following sections explain how to set up and perform disconnected operations:
"Using a CD or DVD for Disconnected Imaging Operations" on page 424
"Using a Hard Disk for Disconnected Imaging Operations" on page 426
Using a CD or DVD for Disconnected Imaging Operations
In ZENworks Linux Management, you can use CDs and DVDs only as the storage medium for an
image to put down, not for an image to be created.
You can put down an image from a bootable or non-bootable imaging CD or DVD using either the
bash prompt or using the ZENworks Imaging Engine menu.
424 Novell ZENworks 7.3 Linux Management Administration Guide
"Using Image Explorer to Customize an Image" on page
Image File Set Usages
How to specify the file set to use
In the Multicast Wizard in the ZENworks Control Center, specify the number of the file
set in the File set field. You must create the file set using the Image Explorer utility.
For more information, see
You can create multiple Preboot bundles that point to the same base image, but to
different file sets of that image.
Use the
parameter on the
s
number 3:
img restorel dellnt4.zmg s3
or
You can enter
img
then select Local image. Specify sfileset (for example, s3) in the Advanced
parameters field.
For details, see
"ZENworks Imaging Engine Commands" on page
Section D.1, "Image Explorer (imgexp.exe)," on page
command. For example, to specify file set
img restore
at the bash prompt to display a menu, select Restore an image,
418, you can exclude
607.
631.
Advertisement
Table of Contents
