Configuring A Kickstart Bundle - Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual

IMPORTANT: If this Preboot bundle has been created on a management device inside the firewall
and you are assigning it to a device outside the firewall, port 8089 must be open both ways
(PUBLIC -> PRIVATE, and PUBLIC <- PRIVATE).
When any device assigned to the AutoYaST bundle boots, the bundle's SUSE Linux installation
work is performed on the device.

30.3.2 Configuring a Kickstart Bundle

A kickstart bundle contains software for installing Red Hat Linux.
Using ZENworks Linux Management, you can install software using a bundle. Software included in
a bundle that is assigned directly is considered mandatory; the software is installed on all assigned
devices (the bundle is directly assigned to the devices, their groups, or their folders).
To configure a kickstart bundle and assign devices to the bundle:
1 In the ZENworks Control Center, click the Bundles tab.
2 Click New > Bundle to start the Create New Bundle Wizard:
3 In the Create New Bundle Wizard, select Preboot bundle, then click Next.
446 Novell ZENworks 7.3 Linux Management Administration Guide